Click here to purchase
This specification covers the procurement requirements for metric corrosion resistant steel retaining rings of the tapered width type with rectangular and beveled cross-sections.
Click here to purchase
This document defines the requirements for heavy-duty hose assemblies suitable for use in 21000 kPa, 135°C aircraft systems whee rapid rate pressure pulsing and torsional/longitudinal flexing may occur in addition to normal hydraulic system loading.
Click here to purchase
This specification covers a titanium alloy in the form of sheet, strip, and plate procured in metric units.AMS 4911 is the inch/pound version of this MAM.These products have been used typically for parts requiring strength up to 400 degrees C, but usage is not limited to such applications.Certain processing procedures and service conditions may cause these products to become subject to stress-corrosion cracking; ARP 982 recommends practices to minimize such conditions.
Click here to purchase
Provides general information for all connector systems, seals, direct connect applications, secondary terminal locks, connector locking feature and position assurance, pin terminals, blade/box, and eyelet/ring terminals and plating.
Click here to purchase
This document describes the design and assembly force guidelines for conventional shipping caps, torque caps, and body plugs. All possible design and applications could not be anticipated in creating these guidelines. Where there are questions of adherence to to this document, such as use of an “off-the-shelf†design, always consult the responsible Ergonomics Department.
Click here to purchase
This specification covers the grain flow pattern requirements in headed bolts, screws, and studs. The heading practice in the manufacture of the bolt, screw, or stud sets the grain flow pattern, but it is also greatly influenced by the fastener design.
Click here to purchase
Scope is unavailable.
SCOPE IS UNAVAILABLE.
Click here to purchase
Scope is unavailable.
Click here to purchase
This specification covers a corrosion and heat resistant, vacuum melted, nickel alloy in the form of investment castings.AMS 5401 is the inch/pound version of this MAM.These castings have been used typically for structural parts requiring moderate strength up to 870 degrees C and oxidation and corrosion resistance up to 980 degrees C, but usage is not limited to such applications.