Click here to purchase
This specification covers aircraft quality metric pins, such as, straight, headless, headed, shouldered, and dowel, in metric sizes. Primarily for use in aerospace propulsion systems requiring metric size pins for use as locks, positioners, guides, plugs, and other similar uses.
Click here to purchase
Not available.
Click here to purchase
No scope available.
This document gives specific and measurable design criteria to be applied at a design review prior to tooling. The specification is formatted as a checklist to aid in its use. The requirements do not apply in all situations so engineering judgment must be used. This is a specification for design criteria; applicable performance specifications (USCAR-2, etc.) must still be performed.
Items in this document are grouped by component as follows:
Terminals
Secondary Terminal Locks
Connectors
Connector Locks
Secondary Connector Locks (Connector Position Assurance, CPA)
Connector Seals
Serviceability
High Voltage (≥60V) Application Requirements
Drawing and General Requirements
Click here to purchase
Incandescent bulbs for use in automotive road illumination.
Click here to purchase
This specification has been declared “SUPERSEDED” by the Aerospace Materials Division, SAE, as of September 1994. The requirements of this specification are embodied in the latest issue of ANSI H35.2, Dimensional Tolerances for Aluminum Mill Products.
Click here to purchase
This specification covers established metric (SI) manufacturing tolerances applicable to non-cellular rubber products ordered to metric dimensions. These tolerances apply to all conditions, unless otherwise noted. The term “exclusive” applies only to the higher figure of the specified range.
Click here to purchase
This specification provides requirements and procedures for hydraulic-pressure leak testing of parts. AMS 2625 is the inch/pound version of this MAM.
Click here to purchase
This standard provides a test method for determining the torque-tension relationship of a fastener finish as applied to a surrogate screw for the purpose of measuring the frictional characteristic of the fastener finish. The results obtained by this test shall be used as a process control attribute of the fastener finish and shall not be utilized for specific applications.